Crestron SWAMP(I)-24X8 Spezifikationen PDF herunterladen (Seite 25)

Crestron SWAMP(I)-24X8 Sonnex™ Multiroom Audio System

Hardware Hookup

Connect the Device

Make the necessary connections as called out in the illustration that follows this

paragraph. Refer to “Network Wiring” on page 16 for additional information. Apply

power after all connections have been made.

Hardware Connections for the SWAMP-24X8

POWER:

From Line Voltage

ANALOG SOURCES:

From Analog Audio Sources

DIGITAL OUT:

To SWAMPE

Multiroom Audio

Expander or

S-EXT1-S Sonnex

Link Over Fiber

Extender

SPDIF SOURCES:

From Digital Audio

Sources

SPDIF OUT:

To Digital Audio

Receiver

SPEAKER OUTPUTS:

To Speakers or SAT-70V/100V

Sonnex Output Transformer

LAN:

10BASE-T/100BASE-TX

Ethernet to LAN

NET:

To Cresnet Devices

Ground

CAUTION: Keep the device unplugged until all the input, network, and speaker

wiring is complete.

CAUTION: Check the speaker wires for shorts and frayed wiring around the

SPEAKER OUTPUTS connectors.

NOTE: Ensure the unit is properly grounded by connecting the chassis ground lug

to an earth ground (building steel).

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the table of specifications.

Four balanced/unbalanced audio inputs are provided, utilizing five-pin terminal

block connectors. For connection details, refer to the following table and diagrams.

Audio Connections

SIGNAL

NAME

BALANCED

AUDIO INPUT

UNBALANCED

AUDIO INPUT

L + Source L + Source L +

L - Source L - Source L -

jumper to GND

G Shield/Ground Ground

R + Source R + Source R +

R - Source R - Source -

jumper to GND

Operations Guide – DOC. 7049B Sonnex™ Multiroom Audio System: SWAMP(I)-24X8 • 19

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron SWAMP(I)-24X8 Spezifikationen Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger Crestron SWAMP(I)-24X8