Crestron Lighting Design Installationsanleitung PDF herunterladen (Seite 60)

230 V Lighting Design Guide

Doc. 4859C | crestron.com

Equipment List Speciﬁcation

The equipment list is based on the requirements collected for the lighting system in the load schedule. This is a

sequential step-by-step process. The information gathered in previous steps is required to complete following

steps. Once all the steps are completed, a complete Bill of Materials (BOM) for the system is created:

• Module selection is based on the number and type of loads.

• Automation Enclosure selection is based on the number of modules and the available space in the

enclosure.

• User interface selection is based on the user control requirements.

• Wiring plan is based on the previous steps and the layout of the environment.

• Control processor is based on the size of the system (large systems should have a dedicated processor).

• Network block selection is based on the layout and distribution of the loads and user interfaces.

• Accessories selection is based on the required accessories (telephone and alarm systems, HVAC control,

intercom systems, occupancy sensors, etc.).

NOTE: Crestron D3 Pro software is the ideal tool for specifying an equipment list. A fully documented help ﬁle

supports the easy-to-use screens and views. It offers the designer a starting place for determining modules and

enclosures. The Crestron D3 Pro software can also generate a load schedule report. Refer to the Crestron website

for detailed information about D3 Pro.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 81 82

Keine Kommentare

Crestron Lighting Design Installationsanleitung Seite 60