Crestron Lighting Design Installationsanleitung PDF herunterladen (Seite 14)

230 V Lighting Design Guide

Doc. 4859C | crestron.com

CAEN-UMP - Universal Mounting Plates

Crestron Universal Mounting Plates (CAEN-UMP Series) are a

complete line of accessory plates, which allow mounting of

non-Crestron equipment to any Crestron Automation Enclosure

(CAEN-Series).

Third-party products such as phone and alarm systems can be

mounted to these plates within an enclosure. The advantage

to using the CAEN-UMP is that a variety of sizes are available

and each plate occupies the same area as one, two, or four

Crestron lighting modules (CLX-Series). The size corresponds

to the number of module spaces and their arrangement within

the enclosure. For example, CAEN-UMP2x2 occupies four

module positions and CAEN-UMP1x1 occupies one module

position. The others (CAEN-UMP2x1 and CAEN-UMP1x2)

occupy two module positions.

Installation

The CAEN-UMP must be mounted in accordance with all national and local codes.

NOTES:

• Adhere to Class 1 wiring requirements when considering the equipment attached to the CAEN-UMPs in an

enclosure.

• Third-party equipment attached to a CAEN-UMP within a Crestron Automated Enclosure should not be

considered part of the Crestron system.

Use the four screws (8B x 1/4 inch, supplied) to attach a CAEN-UMP to an enclosure. Crestron recommends that the

keyholes on the plates be located toward the outer edges of the enclosure. As a result, the ﬂanges of the plates do

not overlap each other when positioning any combination of CAEN-UMP2x1s, CAEN-UMP1x1s, or lighting modules

side-by-side in an enclosure.

Refer to the CAEN-UMP product page on the Crestron website for more information.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 81 82

Keine Kommentare

Crestron Lighting Design Installationsanleitung Seite 14