
Crestron TPS-MEM16MB & TPS-MEM32MB Flash Memory
Installation Guide - DOC. 5927 Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB •• 3
titled 'Flash Total Size'. The amount of flash memory residing in the user
interface is shown.
Installation
CAUTION: Installation of new memory module results in the loss of
any program uploaded prior to module replacement. Be sure to have the
program safely saved to a PC if the intent is to upload again.
TPS memory modules are designed for installation into a specific
memory socket internal to all TPS user interfaces. TPS user interfaces
vary; there are tilt and lectern models. As a result, the installation
procedure for each model differs. The only tools required for either
procedure are a #1 Phillips screwdriver and a grounding strap (or
grounded workstation).
Tilt Model Installation Procedure
CAUTION: The memory module and the TPS tilt-model touchpanel
contain ESD sensitive devices. Perform the following procedure while
wearing a grounding strap that is properly grounded or on a grounded
workstation to avoid damaging the module and/or the user interface.
NOTE: If the angle of the touchscreen needs to be adjusted, refer to the
latest revision of the touchpanel Operations Guide for instructions of how
to use the touchpanel position lock buttons. The latest version of the
appropriate Operations Guide can be obtained from the Downloads page
(MANUAL Library) of the Crestron website (www.crestron.com). New
users are required to register to obtain access to the FTP site.
NOTE: The diagrams in this procedure show a TPS-5000 touchpanel,
but the steps for all other TPS touchpanels are identical.
1. If the optional external power pack is utilized, disconnect the
plug of the power pack from the touchpanel rear port labeled
24VDC 2A.
2. To prevent errors when re-connecting, label and disconnect all
cables attached to the touchpanel rear panel ports.
Kommentare zu diesen Handbüchern