Crestron TPS-MEM16MB Installationsanleitung PDF herunterladen (Seite 16)

Flash Memory Crestron TPS-MEM16MB & TPS-MEM32MB

12 •• Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB Installation Guide - DOC. 5927

11. Install the touchpanel rear cover by sliding it over any

expansion card connectors that may be present.

12. Re-install the ten cover screws to finger-tight then, using a

#1 Philips screwdriver, tighten the mounting screws an

additional 1/8-turn to secure cover.

13. Apply power to the user interface. If there is no activity, it is

likely that the memory module was improperly replaced.

Repeat the procedure and make sure the new module is

properly seated.

Problem Solving

Troubleshooting

The table on the next page provides corrective action for possible trouble

situations. If further assistance is required, please contact a Crestron

customer service representative.

TPS-MEM16MB & TPS-32MB Troubleshooting

TROUBLE

POSSIBLE

CAUSE(S)

CORRECTIVE ACTION

Improper connection;

module improperly

installed.

Follow installation procedures in

this guide.

Module installed with

reverse polarity.

Open user interface and inspect

module. Reverse polarity, if

necessary.

Damaged memory

module.

Inspect module. If damaged,

contact Crestron customer service.

Touchpanel

does not

operate after

replacement.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Crestron TPS-MEM16MB Installationsanleitung Seite 16