Crestron TPS-MEM16MB Installationsanleitung PDF herunterladen (Seite 11)

Crestron TPS-MEM16MB & TPS-MEM32MB Flash Memory

Installation Guide - DOC. 5927 Flash Memory for TPS User Interfaces: TPS-MEM16MB & TPS-MEM32MB •• 7

18. Re-install the eight base cover screws to finger-tight then,

using a Philips screwdriver, tighten an additional 1/8-turn.

19. Re-connect all cables to the appropriate touchpanel rear panel

ports.

20. If the optional external power pack is utilized, connect the

plug of the power pack to the touchpanel rear port labeled

24VDC 2A.

Lectern Model Installation Procedure

CAUTION: The memory module and the TPS lectern-model user

interface contain ESD sensitive devices. Perform the following procedure

while wearing a grounding strap that is properly grounded or on a

grounded workstation to avoid damaging the module and/or the user

interface.

NOTE: The diagrams in this procedure show a TPS-6000L touchpanel

but the steps for all other lectern-model TPS user interfaces are identical.

This procedure pertains to an interface that is NOT installed into a wall

or lectern. If already installed, refer to the latest revision of the user

interface Operations & Installation Guide or, if applicable, the back box

Installation Guide. Disconnect power and perform the installation

procedure in reverse to remove the user interface. The latest version of

the Operations & Installation Guide can be obtained from the Downloads

page (MANUAL Library) of Crestron’s website (www.crestron.com).

New users are required to register in order to obtain access to the FTP

site.

1. To prevent scratching of the screen (TPS-TPI excluded), place

the touchpanel facedown onto a padded surface.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

Crestron TPS-MEM16MB Installationsanleitung Seite 11