Crestron CHV-TSTATEX Installationsanleitung PDF herunterladen (Seite 43)

Crestron CHV-TSTAT and CHV-THSTAT Thermostats

Operations and Installation Guide – DOC. 8163E Thermostats: CHV-TSTAT and CHV-THSTAT

•

SETUP: OTHER SETTINGS

NO APPLICABLE SETTINGS

Press To Continue

No applicable settings.

SETUP: SENSORS

SENSOR

INTERNAL:

REMOTE 1:

REMOTE 2:

>TEMP HUM

USE OMIT

SLAB

DETECTED: 1 x T

Press To Continue

INTERNAL: Choose USE or OMIT. Choose USE to permit

temperature averaging.

NOTE: Sensor temperature and humidity can be output to

network even if OMIT is chosen.

REMOTE 1 and 2: Choose USE, OMIT, OD (outdoors), or

SLAB (remote sensors only).

NOTE: REMOTE 1 and REMOTE 2 options do not appear

on this screen if these sensors are not connected.

NOTE: Thermostat auto-detects connected remote sensors.

SETUP: HUMIDITY SENSORS

SETUP: H-SENSORS

TRIM

INTERNAL: -5

REMOTE 1: 0

REMOTE 2: 0

% RH

Press To Continue

TRIM: Select -9 – +9. Allows the user to calibrate the

INTERNAL, REMOTE 1 and REMOTE 2 humidity sensors to

match % RH values obtained by other equipment. The values

here are based on a logarithmic index and are not to be

interpreted as units of measurement.

NOTE: For best results, calibration should be performed

when RH is 40% or higher.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 91 92

Keine Kommentare

Crestron CHV-TSTATEX Installationsanleitung Seite 43