Crestron QM-MD8x8 Spezifikationen PDF herunterladen (Seite 17)

Crestron QM-MD8x8 QuickMedia Distribution System

down at the copper connections, pin 1 is on the far right. The following table lists the

pin assignments on the RJ-45 connector.

Pin and Pair Assignment

RJ-45

PIN #

CAT5E

PAIR #

WIRE

COLORS

(568B)

QM ASSIGNMENT

RGB AND AUDIO

QM ASSIGNMENT

COMPOSITE,

S-VIDEO AND AUDIO

1 2 WHITE/ORANGE - RGB RED - CHROMINANCE

2 2 ORANGE + RGB RED + CHROMINANCE

3 3 WHITE/GREEN - RGB GREEN - LUMINANCE

4 1 BLUE + AUDIO + AUDIO

5 1 WHITE/BLUE - AUDIO - AUDIO

6 3 GREEN + RGB GREEN + LUMINANCE

7 4 WHITE/BROWN - RGB BLUE - COMPOSITE

8 4 BROWN + RGB BLUE + COMPOSITE

NOTE: When using Crescat-QM wiring, a cable containing four wires is included

for making Cresnet connections.

Identity Code

All equipment and user interfaces within the network require a unique identity code

(Net ID). These codes are two-digit hexadecimal numbers from 03 to FE. The Net ID

of each unit must match an ID code specified in the SIMPL Windows program.

Refer to “Setting the Net ID in Device Settings” on page 21 for details of the SIMPL

Windows procedure.

Refer to the note on page 24 for a

definition of Viewport.

The Net ID of the MD8x8 has been factory set to 06. The Net IDs of multiple

MD8x8s in the same system must be unique. Net IDs are changed from a personal

computer (PC) via the Crestron Viewport.

NOTE: For detailed information on establishing communication between the PC and

control system, refer to “Communication Settings” on page 25. If communication

cannot be established, refer to the “Troubleshooting Communications” section in the

respective Operations Guide for the control system.

There are two different methods—Method A or Method B—for setting the Net ID:

Method A (Cresnet address-settable ID), described below, applies to devices in a

Cresnet system with a 2-Series control system that require a single unit be the only

network device connected to the control system.

Method B (Touch Settable ID or TSID), which begins on the following page, applies

to all TSID-ready devices in a Cresnet system with 2-Series control system upgrade

file (CUZ) version 3.029 or later. TSID functionality makes it possible for the

control system to recognize a network device via its serial number, which is stored in

the device’s memory. This method does not require that any devices be disconnected

from the network; Net IDs may be set with the entire Cresnet system intact. This

method requires the use of the Crestron Viewport version 3.35 or later.

Use the appropriate method to set the Net ID.

Method A (Cresnet address-settable ID)

1. Ensure that the device requiring a Net ID change is the only unit connected

to the control system.

2. Open the Crestron Viewport.

Operations Guide - DOC. 6260 QuickMedia Distribution System: QM-MD8x8 • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron QM-MD8x8 Spezifikationen Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller Crestron QM-MD8x8