Crestron QM-MD8x8 Spezifikationen PDF herunterladen (Seite 13)

Crestron QM-MD8x8 QuickMedia Distribution System

While in the system mode, pressing V will indicate where the video portion of a

signal is routed. For more information on the MD8x8’s operating modes, refer to

“Operating Modes” on page 30.

SYS (System)

Press this button to set the MD8x8 to the system mode. When the accompanying

LED is illuminated, all switching functions are controlled by the Crestron control

system. While in the system mode, routing paths for each input can be viewed on the

front panel by pressing an input or output button. For more information on the

MD8x8’s operating modes, refer to “Operating Modes” on page 30.

LOCAL

Press this button to set the MD8x8 to the local mode. When the accompanying LED

is illuminated, all switching functions are controlled by MD8x8’s front panel. For

more information on the MD8x8’s operating modes, refer to “Operating Modes” on

page 30.

ENTER

When switching signals in the local mode, switch changes are not implemented until

the ENTER button is pressed. After selecting an input source and an output

destination, press ENTER to implement the change.

IN (1 through 8)

Select a QM input source to view or switch (depending on the selected operating

mode) by pressing the corresponding IN button. If audio break is enabled (indicated

by the AUDIO BREAK LED), only the audio or video portion (indicated by the A or

V LED) will be switched or viewed (depending on the selected mode). For

information on operating modes and selecting QM input sources, refer to “Operation”

on page 30.

OUT (1 through 8)

Select a QM output destination to view or switch (depending on the selected

operating mode) by pressing the corresponding OUT button. If audio break is

enabled (indicated by the AUDIO BREAK LED), only the audio or video portion

(indicated by the A or V LED) will be switched or viewed (depending on the selected

mode). For information on operating modes and selecting QM output destinations,

refer to “Operation” on page 30.

SETUP LED and Pushbutton

The MD8x8 is TSID ready. Located on the rear of the MD8x8, the SETUP

pushbutton and its associated LED are located on the rear panel and are used for

setting up the unit’s network ID during the initial configuration of a Cresnet system

or when the device is being added/replaced. Refer to “Method B (Touch Settable

ID)” on page 14 for detailed information.

Operations Guide - DOC. 6260 QuickMedia Distribution System: QM-MD8x8 • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Keine Kommentare

Crestron QM-MD8x8 Spezifikationen Seite 13