Crestron ATC-AUDIONET Installationsanleitung PDF herunterladen (Seite 11)

Crestron ATC-AUDIONET Internet Radio Tuner Card

5. As shown in the following photo, position the ATC-AUDIONET card so

the print on the faceplate is right side up and the side rails of the card slide

into the plastic slots mounted on left and right inside walls of the host

system.

ATC-AUDIONET Installed in an AMS

6. Push the ATC-AUDIONET card into the slot until it stops at the rear

connector, and then push again until the ATC-AUDIONET card snaps into

place.

7. Secure the card in place by tightening the two slotted screws by hand. The

screwdriver slots are provided for removal only.

Ethernet Configuration

Once the tuner card is installed, users need to specify the Ethernet settings of the

ATC-AUDIONET.

NOTE: When installing the ATC-AUDIONET, the IP ID and IP address of the

control system need to be specified for the ATC-AUDIONET. This can be done via

the front panel controls or a custom program.

NOTE: When installed in an Adagio system, the ATC-AUDIONET will only work

with a custom program that includes an ATC-AUDIONET.

NOTE: When installing in an Adagio System, an IP table entry that identifies the

host system as the control system must be created in the ATC-AUDIONET’s IP

table. This is done automatically by SystemBuilder™ but can also be done through

Crestron Toolbox™ or through the Installer Tools (available on an Adagio system

that was programmed by SystemBuilder to include an ATC-AUDIONET).

For instructions on changing the Ethernet settings, refer to “Appendix” on page 25.

Operations & Installation Guide – DOC. 6933A Internet Radio Tuner Card: ATC-AUDIONET • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Keine Kommentare

Crestron ATC-AUDIONET Installationsanleitung Seite 11