Crestron TPMC-9L Installationsanleitung PDF herunterladen (Seite 35)

Crestron TPMC-9L 9” Wall Mount Touch Screen

7. Tighten the mounting screws evenly and only enough to compress the

mounting clips and secure the TPMC-9L squarely in the mounting surface.

Do not over-tighten the screws.

Installing the Faceplate

Use the Crestron Engraver software package to obtain a custom-engraved faceplate

for the TPMC-9L. Install the faceplate as follows.

1. Carefully position the faceplate over the face of the touch screen.

2. Ensure that the faceplate is oriented properly and press against the

TPMC-9L until the faceplate snaps into place.

Touch Screen Removal

If it is necessary to remove the touch screen after it has been installed into a

mounting surface, complete the following steps in the order provided to remove the

touch screen. The only tool required is a #2 Phillips tip screwdriver.

1. Lift one edge of the faceplate to free it from the touch screen and lift it off.

Do not apply excessive pressure to the touch screen.

2. Loosen and remove the screws that secure touch screen to the mounting

option in use.

3. Using equal pressure, carefully remove the touch screen from the opening.

If necessary, secure and label the attached cables before disconnecting them from the

back of the touch screen.

Hardware Hookup

Ventilation

The TPMC-9L should be used in a well-ventilated area. The venting holes should not

be obstructed under any circumstances. If the TPMC-9L is hot to the touch, consider

using forced air ventilation.

To prevent overheating, do not operate this product in an area that exceeds the

environmental temperature range listed in the table of specifications. Consideration

must be given if installed in a closed or multi-unit rack assembly since the ambient

operating temperature of the environment may be greater than the ambient room

temperature. Contact with thermal insulating materials should be avoided on all sides

of the unit.

Connect the Device

Make the necessary connections as called out in the illustration on the following

page. Refer to “Network Wiring” on page 12 before attaching the 4-position terminal

block connector. Apply power after all connections have been made.

When making connections to the TPMC-9L, use Crestron power supplies for

Crestron equipment.

Operations & Installation Guide – DOC. 7030F 9” Wall Mount Touch Screen: TPMC-9L • 31

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Keine Kommentare

Crestron TPMC-9L Installationsanleitung Seite 35