Crestron TPMC-9L Installationsanleitung PDF herunterladen (Seite 34)

9” Wall Mount Touch Screen Crestron TPMC-9L

1. Locate an area on the wall that is free of miscellaneous wiring and studs.

2. Make a small hole near the middle of the designated site, and verify that the

location is suitable.

3. Using masking tape (or equivalent), fasten the template to the wall; verify

that the template is level, and trace the opening shape on the wall.

4. Remove the template, and then cut out and remove the traced shape to

produce the required opening.

NOTE: Before inserting the TPMC-9L in the mounting hole, ensure that all required

cables have been installed in the wall.

5. Install the four supplied #6-AB x 2-1/2” screws and mounting clips as

shown in the following diagram (two on the top and two on the bottom).

a. Insert the screws through the touch screen flange and then through the

larger hole in the mounting clip.

b. Thread the screws through the smaller hole in the mounting clips and

tighten the screws only enough that the mounting clips are brought

flush with the rear of the touch screen flange. Do not compress the

mounting clips at this time.

Attaching the Screws and Mounting Clips

Mounting Screws

(4)

6-AB x

2-1/2”

(2014276)

Mounting Clips

Thread Screws Through Clips At

This End

6. Connect the Cresnet cable, using the supplied mating connector, to the

Cresnet port; attach the Ethernet cable, if required. Attach video cables,

using the supplied mating connectors and position the TPMC-9L in the

mounting hole. Refer to “Hardware Hookup” which starts on page 31.

30 • 9” Wall Mount Touch Screen: TPMC-9L Operations & Installation Guide – DOC. 7030F

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Keine Kommentare

Crestron TPMC-9L Installationsanleitung Seite 34