Crestron DigitalMedia Room Controller DM-RMC-100 Installationsanleitung PDF herunterladen (Seite 19)

Crestron DM-RMC-100-S DigitalMedia 8G™ Fiber Receiver 100

Rack Mounting

To mount the DM-RMC-100-S on the left or right rail of a rack, use two rack

mounting screws (not included). The following illustration shows mounting of the

DM-RMC-100-S on the right rail of a rack.

Mounting the DM-RMC-100-S on Rack Rail (Right Rack Rail Shown)

Rack Mounting

Screws

(Not Included)

Hardware Hookup

Make the necessary connections as called out in the illustrations on the following

page. Refer to “Network Wiring” on page 11. Apply power after all connections

have been made.

When making connections to the DM-RMC-100-S, use Crestron power supplies for

Crestron equipment.

NOTE: Ensure that the unit is properly grounded by connecting the chassis ground

lug to an earth ground (building steel).

NOTE: For optimum performance, Crestron recommends using CresFiber 8G fiber

optic cable.

NOTE: Fiber optic cable connectors and cable ends should be protected from

contamination and scratching at all times. When cable is not connected, protect the

optical receiver on the DM-RMC-100-S by using the included cap. Fiber ends should

be handled carefully and the cable should not be bent or coiled tightly.

Operations & Installation Guide – DOC. 7067B DigitalMedia 8G™ Fiber Receiver 100: DM-RMC-100-S • 13

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Keine Kommentare

Crestron DigitalMedia Room Controller DM-RMC-100 Installationsanleitung Seite 19