Crestron DigitalMedia Room Controller DM-RMC-100 Installationsanleitung PDF herunterladen (Seite 17)

Crestron DM-RMC-100-S DigitalMedia 8G™ Fiber Receiver 100

Setup

Network Wiring

When wiring the DM network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

CAUTION: Failure to use Crestron power supplies could cause equipment

damage or void the Crestron warranty.

• Provide sufficient power to the system.

• For DigitalMedia 8G Fiber wiring, CresFiber 8G is recommended. Refer to

the following table for the maximum transmission distance of CresFiber 8G

and other fiber optic cable.

DigitalMedia 8G Fiber Wiring and Maximum Transmission Distance

CABLE TYPE MAXIMUM TRANSMISSION DISTANCE

CresFiber 8G

1000 feet (~300 meters)

CresFiber 500 feet (~150 meters)

Generic OM3 500 feet (~150 meters)

For complete wiring guidelines, refer to the latest version of the Crestron

DigitalMedia Design Guide (Doc. 4789).

The DM-RMC-

100-S also uses high-speed Ethernet for communications between the

device and a control system, computer, media server, and other IP-based devices.

For general information on connecting Ethernet devices in a Crestron system, refer to

the latest version of the Crestron e-Control

Reference Guide (Doc. 6052), which is

available from the Crestron Web site (

www.crestron.com/manuals). For information

specifically related to Ethernet connectivity using DigitalMedia devices, refer to the

latest version of the Crestron IP Considerations Guide (Doc. 4579), which is also

available from the Crestron Web site (

www.crestron.com/dmresources).

Identity Code

NOTE: In the SIMPL™ Windows program, the IP ID of the DM-RMC-100-S is

assigned automatically and does not require additional programming when the

DM-RMC-100-S is dropped onto an output card of a DM switcher. Use the

information below when the DM-RMC-100-S is dropped directly into an Ethernet

slot on the control system in SIMPL Windows without a DM switcher.

The IP ID is set within the DM-RMC-100-S IP table using Crestron Toolbox™.

For information on setting an IP table, refer to the Crestron Toolbox help file.

The IP IDs of multiple DM-RMC-100-S devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the SIMPL

Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Operations & Installation Guide – DOC. 7067B DigitalMedia 8G™ Fiber Receiver 100: DM-RMC-100-S • 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron DigitalMedia Room Controller DM-RMC-100 Installationsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Crestron DigitalMedia Room Controller DM-RMC-100