Crestron PRO2 Bedienungsanleitung PDF herunterladen (Seite 9)

SYMETRIX SOLUTIONS: TECH TIP

February 2014

6408 216th Street SW | Mountlake Terrace, WA 98043 USA

T +1.425.778.7728 F +1.425.778.7727 | www.symetrix.co

The controller numbers on the Crestron Touch Panel GUI match the control

numbers on the Crestron Mobile controller in the Simpl program as shown

in the following ﬁgure. For example the digit 1 on the touch screen has a

controller number of 161 which becomes the L1_1_press control signal on the

signal press_161 which in turn is sent to the SymNet Simple ATI Dialer user

module to indicate that the digit 1 has been pressed which in turn sends and

API command to the Symetrix device to dial the digit 1.

Figure 13. The Crestron Mobile touch screen interface with the corresponding control

signals to the Touch Panel design.

Compile and upload this program and send it to the IP address of the iPad.

See the next section for ﬁnding the IP address of the iPad.

Using the Crestron iPad application

Once the Crestron iPad application has been downloaded, launch the

application on the iPad. As an alternative to using the Crestron iPad

application, both the Vision Tools Pro-e project and the Crestron Simpl

application can be modiﬁed to support XPanel or other Crestron touch panels.

Before conﬁguring the iPad, note the IP address shown on the bottom of the

iPad display as shown in the following ﬁgure. This is the address that the Vision

Tools Pro-e touch panel design program use for upload of the user interface

Figure 14. iPad IP address at the bottom of the iPad display.

To conﬁgure the system, select Add System and enter the ﬁelds as shown in

the following ﬁgure. Select Yes for Use Local File. By default the system will

use Port 41790 for Part A and 41791 for Port B. While no password is required

by default, a password must be entered. In this example, enter any password.

Press save when done.

Figure 15. The configuration screen on the Crestron iPad application.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Crestron PRO2 Bedienungsanleitung Seite 9