Crestron CNMK Spezifikationen PDF herunterladen (Seite 11)

Crestron CNMK Mouse/Keyboard Controller

Operations Guide – DOC. 5699A Mouse/Keyboard Controller: CNMK • 7

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to

avoid nicking the conductors. Twist together the ends of the wires that share a pin on

the network connector, and tin the twisted connection. Apply solder only to the ends

of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.

Insert the tinned connection into the Cresnet connector and tighten the retaining

screw. Repeat the procedure for the other three conductors.

Identity Code

Every equipment and user interface within the network requires a unique identity

code (Net ID). These codes are two-digit hexadecimal numbers from 03 to FE. The

Net ID of each unit must match an ID code specified in the SIMPL Windows

program. Refer to “Setting the Net ID in Device Settings” on page 11 for details of

the SIMPL Windows procedure.

Refer to the note on page 13 for a

definition of Viewport.

The Net ID of the CNMK has been factory set to 28. The Net IDs of multiple

CNMKs in the same system must be unique. Net IDs are changed from a personal

computer (PC) via the Crestron Viewport.

NOTE: For detailed information on establishing communication between the PC and

control system, refer to “Communication Settings” on page 13. If communication

cannot be established, refer to the “Troubleshooting Communications” section in the

latest version of the 2-Series Control System Reference Guide (Doc. 6256) or the

respective Operations Guide for the other control systems, which are available from

the Crestron website.

Set the CNMK Net IDs as follows:

1. Ensure that the CNMK is the only device connected to the control

system.

2. Open the Crestron Viewport.

3. From the Viewport menu, select Functions | Set Network ID. The

software checks the baud rate and then opens the "Set Network ID"

window.

4. In the "Set Network ID" window, select the CNMK from the Current

Network Devices text window.

5. Select the new Net ID for the CNMK from the Choose the new network

ID for the selected device (Hex): text box.

6. Click Set ID to initiate the change. This will display the "ID command

has been sent" window.

7. In the "Command Complete" window, click OK.

8. In the Current Network Devices text window, verify the new Net ID

code.

9. In the "Set Network ID" window, click Close.

NOTE: The new Net ID code may also be verified by selecting Diagnostic | Report

Network Devices in the Viewport (alternately, select F4).

10. Repeat this procedure for each CNMK to be added to the system.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron CNMK Spezifikationen Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Crestron CNMK