Crestron C2N-IVDS24X24 Spezifikationen PDF herunterladen (Seite 14)

Intercom Video Distribution System Crestron C2N-IVDS24x24

from the network; Net IDs may be set with the entire Cresnet system intact. This

method requires the use of the Crestron Viewport version 3.35 or later.

Use the appropriate method to set the Net ID.

Method A (Cresnet address-settable ID)

1. Ensure that the device requiring a Net ID change is the only unit connected

to the control system.

2. Open the Crestron Viewport.

3. From the Viewport menu, select Functions | Set Network ID. The software

checks the baud rate and then opens the "Set Network ID" window.

4. In the "Set Network ID" window, select the device requiring a Net ID

change from the Current Network Devices text window.

5. Select the new Net ID for the device from the Choose the new network ID

for the selected device (Hex): text box.

6. Click Set ID to initiate the change. This will display the "ID command has

been sent" window.

7. In the "Command Complete" window, click OK.

8. In the Current Network Devices text window, verify the new Net ID code.

9. In the "Set Network ID" window, click Close.

NOTE: The new Net ID code may also be verified by selecting Diagnostic | Report

Network Devices in the Viewport (alternately, select F4).

10. Repeat this procedure for each additional network device requiring a Net ID

change.

Method B (Touch Settable ID)

Before using this method, you should have a list of all current network devices and

their Net IDs, to avoid assigning duplicate IDs.

Set Net ID by TSID

These procedures are for TSID-enabled network devices during the initial

configuration of a Cresnet system or when such devices are being added/replaced.

1. Ensure that all network devices are connected to the control system.

2. Open the Crestron Viewport version 3.35 or later.

3. From the Viewport menu, select Functions | Assign Cresnet ID by Serial

Number. The “Set Net ID by TSID” window appears. The window is first

displayed with the data fields empty.

4. Click on the Search for Touch Settable Devices button. The system

searches the network and lists all TSID-enabled devices found. The list is

similar to the report produced by pressing F4 (Report Network Devices);

the first eight digits of each line constitute the TSID number (hexadecimal

form of the serial number).

10 • Intercom Video Distribution System: C2N-IVDS24x24 Operations Guide - DOC. 6171

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Keine Kommentare

Crestron C2N-IVDS24X24 Spezifikationen Seite 14