Crestron CT-3000 Spezifikationen PDF herunterladen (Seite 15)

Crestron e-control Database Manager SW-DBM

15 •• Basic Server Setup Installation & Reference Guide — DOC. 5823

from Control System button to display the current listing. Verify that the IP

address for the PC running the CNX Gateway (often but not necessarily the

server itself) appears with an IP ID of 03. If it does not appear, use the Add…

button to add an entry for IP ID 03. Then click the Send IP Table to Control

System button.

8. Switch to TCP/IP. Now that TCP/IP is properly configured, the Ethernet

connection can be used for all subsequent system communications (from

SIMPL Windows, Test Manager, Vision Tools Pro-e, and all Viewport

functions). See the section below titled Test Communications. Open the

Viewport and issue the Setup | Communications Settings… command to

reconfigure communications for TCP/IP. The serial cable can now be

removed.

9. Install control system program. Upload the compiled SIMPL Windows

program file (.bin file) to each control system.

As supplied, the demo programs are configured for a single CNMSX-PRO control

system. For other models, use SIMPL Windows to convert the program as follows

and recompile:

CNMSX-AV.

In the Configuration Manager, drag & drop a CNMSX-AV system onto the CNMSX-PRO.

The converted system does not have a front panel, so compile “notices” appear — which

can be ignored.

CNRACKX. Install a CNXCOM-2 card in slot 4 and use Port A.

In the Configuration Manager, drag & drop a CNRACKX system onto the CNMSX-PRO.

The converted system has a CNXCOM-2 card in slot 4; use Port A. The converted system

does not have a front panel, so compile “notices” appear — which can be ignored.

10. Install touchpanel pages. Upload the compiled VT Pro project file (.hex

file) to each control system.

As supplied, the demo touchpanel file, demomail.vtp (which contains pages for

all five demos), is configured for a LC-3000 touchpanel; and the accompanying

.hex file is compiled for same. This file however also works fine with an CT-3000,

CT-3500, and a VT-3500. If you have one of these models, go ahead and upload the

.hex file as is. If you are working with another panel, convert the file to your

target panel and recompile.

Test Communications

At this point, test your connections.

RS-232 Control Systems

Use the Viewport to verify communications between the server and the CNX control

system. Select Diagnostics | Establish Communications. If properly connected, the

PC responds with the COM port and baud rate.

TCP/IP Control Systems

First test the IP address of the CNX control system by “pinging” it. From a

networked PC bring up an MS-DOS prompt (Windows 95/98) or “Command

Prompt” (Windows NT) and type “ping <IP ADDRESS>”, as shown below. The

control system responds with several lines “Reply from address < IP ADDRESS >…”.

If no response is received from the “ping” to the IP address of the CNX control

system, repeat the procedure in “Control System Side, TCP/IP,” page 14.

C:\WINDOWS>ping 132.149.2.2

Pinging 132.149.2.2 with 32 bytes of data:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 93 94

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron CT-3000 Spezifikationen Seite 15

Kommentare zu diesen Handbüchern