Crestron BB-1000L Bedienungsanleitung PDF herunterladen (Seite 8)

Mud Mount Kits Crestron MMK-1000L & WMKM-1000L

Insert and Secure Mud Ring Plate into PMK-1000L (or BB-1000L)

PMK-1000L

DRYWALL

HOLES FOR DRYWALL SCREWS

(NOT INCLUDED)

SCREW LENGTH SHOULD NOT

EXCEED DRYWALL THICKNESS

BY MORE THAN ½” (12.7 MM)

MUD RING PLATE

(2004810)

5. When the mud ring plate is in position, bend the top two flanges of the plate

upward and the bottom two flanges downward.

• If mounting into the PMK-1000L, bend the flanges approximately

90 degrees.

• If mounting into the BB-1000L, bend the flanges back as far as they

can go.

6. Use four standard drywall screws (length should not exceed drywall

thickness by more than ½ inch) to secure the mud ring plate to the rest of

the assembly. The screws pass through the clearance holes in the

PMK-1000L (or BB-1000L) and are secured in the extruded holes of the

adjustment plates.

7. Verify that the mud ring plate is level.

NOTE: Do not overtighten screws. Doing so may over-dimple or rip the mud ring

plate.

8. Use a #2 Phillips screwdriver and tighten the drywall screws by hand so that

they slightly dimple into the holes in the mud ring plate.

9. Apply drywall joint compound as needed to finish the cutout. Avoid

covering the four tapped mounting holes.

10. Run the necessary cables for the controller and secure them behind the

drywall.

11. When dry, the controller can be installed using the four tapped holes in the

PMK-1000L. Refer to the latest revision of the APAD Installation and

Operations Guide (Doc. 6455) for installation instructions. Refer also to the

comprehensive illustration on the following page.

6 • Mud Mount Kits: MMK-1000L & WMKM-1000L Installation Guide – DOC. 6062A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Crestron BB-1000L Bedienungsanleitung Seite 8