Crestron BB-1000L Bedienungsanleitung PDF herunterladen (Seite 6)

Mud Mount Kits Crestron MMK-1000L & WMKM-1000L

Drywall Cutout Template and Dimensions (supplied with WMKM-1000L only), 2 of 2

6 in

(152 mm)

4 1/2 in

(115 mm)

3/4 in

(19 mm)

11/16 in

(18 mm)

4 1/2 in

(115 mm)

5 7/8 in

(150 mm)

Installation

This section provides an installation procedure for each Mud Mount Kit. The

“MMK-1000L Procedure” starts below and the “WMKM-1000L Procedure” starts

on page 7. Be sure to review each procedure before starting.

MMK-1000L Procedure

This section provides the necessary steps for the assembly of the MMK-1000L with

either the BB-1000L or PKM-1000L. It is assumed that the BB-1000L or

PKM-1000L has been secured to the stud according to the instructions in the latest

revisions of their Installation Guides (Doc. 6060 and Doc. 6061 respectively). It is

also assumed that drywall is in place and a rectangular cutout for the controller is

made in the drywall.

Complete the steps in the order provided. The only tools or materials required and

not supplied are four standard drywall screws, #2 Phillips screwdriver, a level and

tools/material to apply drywall joint compound.

CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity

above and below the controller for heat dissipation.

NOTE: The illustrations in this procedure show the installation of the MMK-1000L

with the PMK-1000L. Even though the illustrations only show the PMK-1000L, they

are identical for the BB-1000L.

1. Pass a adjustment plate through the opening and align its two center holes

with the top two pins on the PMK-1000L. Verify that the pins on the

adjustment plate are not between (facing) the adjustment plate and the

PMK-1000L. Refer to the illustration on the following page for visual

guidance.

4 • Mud Mount Kits: MMK-1000L & WMKM-1000L Installation Guide – DOC. 6062A

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Keine Kommentare

Crestron BB-1000L Bedienungsanleitung Seite 6