Crestron TPS-3000L Spezifikationen PDF herunterladen (Seite 16)

6.4" Lectern/Wall Mounted Touchpanel Crestron Isys™ TPS-3000L

MAIN MENU

This menu can also be obtained via

digital reserved join number, 17242.

To configure the unit, it may be necessary to access a series of setup screens prior to

viewing run-time screens that are loaded into the touchpanel for normal operation.

The MAIN MENU for configuring the touchpanel appears when a finger is held to

the touchscreen as power is applied. Remove your finger when the message “SETUP

MODE” appears on the touchscreen.

NOTE: The SETUP MODE can also be accessed through the Viewport Utility if the

touchpanel is connected directly to a PC.

Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four

buttons: Touch Screen Calibration, Exit and Run Program, Setup, and

Diagnostics.

The Exit and Run Program button verifies that all of the setup information has

been saved to EEPROM and displays the main page that has been programmed into

your system. The remaining buttons on the MAIN MENU open other menus, which

are discussed in subsequent paragraphs.

Calibration Menu

CALIBRATION MENU

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button's image. Select the Touch Screen Calibration button to

display the CALIBRATION MENU, shown to the left. The CALIBRATION MENU

offers the choice to initiate calibration with the Perform Calibration button or

return to the previous screen with the Return button. Choose an option by touching

the correct button.

If you proceed to calibrate the touchpanel, the screen displays the message "Touch

Upper Left" centered on the panel with a cross hair in the corner. Touch the cross

hair in the corner of the screen to initiate calibration. Another message, "Touch

Upper Right", appears with a cross hair in the correct corner. Touch the corner of the

screen. A final message, “Touch Lower Right”, appears with a cross hair in the

correct corner. Touch the corner of the screen to conclude calibration and return to

the MAIN MENU.

NOTE: When touching the screen during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and

return to the CALIBRATION MENU without saving calibration data, create a

calibration error by touching the screen in an area that is opposite from the instructed

area.

Setup Menu

SETUP MENU

To obtain the SETUP MENU, shown to the left, press the Setup button from the

MAIN MENU. The SETUP MENU offers a series of buttons, which opens

additional menus and displays, which are detailed in subsequent paragraphs. After

setup parameters have been set, select the Return button to return to the MAIN

MENU.

NOTE: For convenience, the current CRESNET ID setting is displayed in the lower

left corner.

NOTE: All touchpanel settings are automatically saved in non-volatile memory.

12 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L Operations Guide – DOC. 6077

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron TPS-3000L Spezifikationen Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Crestron TPS-3000L