Crestron TPS-3000L Spezifikationen PDF herunterladen (Seite 13)

Crestron Isys™ TPS-3000L 6.4" Lectern/Wall Mounted Touchpanel

Lectern Mounting

If the touchpanel is to be installed into a lectern, the touchpanel must be set to the

“Inverted” configuration. The “Inverted” configuration provides optimum viewing

when installed into a lectern. This configuration requires the pushbuttons to be

placed on the right side of the screen the screen orientation set to “Inverted”

operation (refer to “Screen Settings” on page 15 for instructions), and the connectors

to be located at the top of the touchpanel. Refer to the following diagram. Before

installing the touchpanel in the “Inverted” configuration, the pushbuttons must be

reoriented to match the position of the touchpanel. Follow the instructions below to

reorient the pushbuttons.

Pushbutton Layout and Join Number Assignment-Lectern Mount

NOTE: This Procedure should be done before installing the touchpanel.

Required Tools

 #1 Phillips tip screwdriver

1. Place the touchpanel on a flat surface.

2. Remove the faceplate (if installed) and the pushbuttons from the

touchpanel. Number the pushbuttons 1 through 5 (with 1 being the button in

the top position) as they are removed.

3. Use a #1 Phillips screwdriver to remove the two screws that hold down the

pushbutton circuit board. Refer to the following diagram for screw

locations.

Pushbutton Circuit Board (Top View)

Ribbon Cable

Screws

Operations Guide – DOC. 6077 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Keine Kommentare

Crestron TPS-3000L Spezifikationen Seite 13