Crestron FlipTop FT-TS600 Installationsanleitung PDF herunterladen (Seite 19)

Crestron FT-TSC600 FlipTop Touch Screen Control System

Operations & Installation Guide – DOC. 7593A FlipTop Touch Screen Control System: FT-TSC600 • 15

Setup

Network Wiring

When wiring the Cresnet or Ethernet network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

CAUTION: Insufficient power can lead to unpredictable results or damage

to the equipment. Use the Crestron Power Calculator to help calculate how

much power is needed for the system (

www.crestron.com/calculators).

• For Cresnet networks with 20 or more devices, use a Cresnet Hub/Repeater

(CNXHUB) to maintain signal quality.

• For more details, refer to “Check Network Wiring” on page 38.

The FT-TSC600 can also use high-speed Ethernet for communications between the

device and a control system, computer, media server, and other IP-based devices.

For general information on connecting Ethernet devices in a Crestron system, refer to

the Crestron e-Control



Reference Guide (Doc. 6052) at

www.crestron.com/manuals.

Identity Code

NOTE: The latest software can be downloaded at www.crestron.com/software.

Net ID

The Net ID of the FT-TSC600 has been factory set to 02. This Net ID is defined as

the “Master” control system.

IP ID

The IP ID is set within the FT-TSC600’s IP table using Crestron Toolbox™. For

information on setting an IP table, refer to the Crestron Toolbox help file. The IP IDs

of multiple FT-TSC600 devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the Crestron

Studio™ or SIMPL Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Keine Kommentare

Crestron FlipTop FT-TS600 Installationsanleitung Seite 19