Crestron D3 PRO Bedienungsanleitung PDF herunterladen (Seite 13)

• Fixed bug where checking the box to mark an interface as virtual, then cancelling out

of the dialog would reset the Bill Of Materials, thus losing any changes you may have

made.

• Fixed bug where clicking on the Bill Of Materials tab in the Properties dialog would

cause a delay before the tab was actually shown.

v2.0.2

• Fixed bug that could cause a program build to fail (only on very rare occasions)

• Updated tooltip for Toolbox icon on toolbar (still referred to Viewport)

v2.0.1

• Added message box when exiting Remote System Export and Touchpanel Export

Properties dialogs. This message box reminds the user that the actual .rsd file will not

be updated until the program is built.

• Fixed bug where the PAC2 room information was not being updated properly if it was

in a CAEN enclosure and the enclosure was moved to a new room.

• Put up a message box if, during a Replace With operation, the new device could not

be added to the program for some reason.

• Updated the Bill Of Materials report where a “/” in the Category name would cause

the formulas in that category to fail.

• Updated the Bill Of Materials report to show “N/A” in red for products that are in the

project but had no pricing information available.

• Updated text in message box that appears when “Reset RSD…” is pressed in the

Remote System Export dialog.

v2.0.0

• Toolbox is now fully integrated into the application, and is used for all

communications. Viewport is no longer used.

• Fixed bug where editing a step in Programming View immediately after switching

from another View could actually edit a different step in the project.

• Fixed crash that occurred with interfaces marked as “virtual”. Application could crash

when the Properties dialog was closed.

• Fixed bug where editing multiple steps at one time (by using the control key in the

Edit Step dialog) would not always update all selected steps.

• Fixed bug where, if D3 Pro had crashed, and there was a backup of your project

available, if you answered “No” to the initial dialog asking to restore from the backup,

then manually tried to open the project and answered “Yes” to the second dialog, the

Autosave project would open, but then the original project would open immediately

afterwards.

• Show dialog when a device that requires a parent device (e.g. an RF dimmer can is

linked a particular gateway) is added to the project. This dialog will prompt to select

which existing parent to attach it to, or allows the user to add a new parent device.

• Fixed bug where using the “Set Network IDs” dialog could cause a subsequent

program build to fail. The workaround was to re-save the project and rebuild.

• Allow Global Expressions to be edited by double-clicking in the text area which lists

the actual expression.

• When a Remote System Import file is changed, all existing commands are removed

before the new commands are imported.

• Fixed bug where a “Replace With…” performed on a CLW dimmer/switch in the

Interface would not retain the attached load.

• Fixed bug where CLW slaves could not be renamed

• Fixed crash that could occur in rare cases while running the Lighting Wizard

• Fixed crash that occurred while programming Expression feedback on a subpage

(applies to touchpanels only). Crash would occur if you subsequently tried to open

the properties dialog for the subpage.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron D3 PRO Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Crestron D3 PRO