Crestron SW-WMC Bedienungsanleitung PDF herunterladen (Seite 6)

Prodigy Tools

No Tool Changes

Known Issues

The following are items which may differ than what might be

expected but are by design and are not planned to change.

Serial HW Handshaking (RTS/CTS) is stricter than the

Viewport was. If a device has RTS/CTS on and Toolbox does

not, you will not be able to communicate.

The following issues are known and will be addressed in future

versions.

NEW Before uploading projects to the PLX3, verify that the

remote is awake and communicating with the gateway. If

the PLX3 is asleep, pressing any button on the remote will

wake it and reconnect it to the last gateway it used.

When naming addresses in the address book, do not start

those names with "tcp", "ssl", "usb" or "rs232" as these

while they will work for direct connections will not work

properly if used in indirect connections.

X Generation Processors do NOT support Touch Settable ID

operations. Therefore when there are conflicting TSIDs on a

cresnet network on an X Generation System, The Network

Tree will show these conflicts and not allow any operations

on those devices. In addition there is no way to resolve the

conflict on the X Generation Processor. A work around is to

address the device specifically in the address book and

connect to it using the System Info Tool. Using this tool you

will be able to perform all the same operations you would

have through the Network Device Tree.

Transfer dialogs restrict transfers to one at a time. Use a

script or multiple instances of Toolbox for simultaneous

transfers.

Some error messages leave much to be desired.

USB driver is Unsigned and thus may cause Windows to

attempt to find a better one online or show warnings upon

installation.

6/1/2011 Crestron Toolbox: Crestron Toolbox Rele…

crestron.com/…/toolbox_2_26.html 6/147

1 2 3 4 5 6 7 8 9 10 11 ... 146 147

Keine Kommentare

Crestron SW-WMC Bedienungsanleitung Seite 6