Crestron CPU2 Spezifikationen PDF herunterladen (Seite 11)

Crestron RACK2 2-Series Card Cage System

RACK2 Physical View – Rear

Slot 1

Slot 2

Slot 3

Slot 4

65 7 8 9 10 11 12 13 14 15 16

Memory Expansion Slot

Z Bus

Y Bus

MEMORY

EXPANSION

Four rubber feet (supplied) can be affixed to the bottom of the RACK2 to provide

stability and to prevent slippage when mounted on a flat surface. The unit may also

be rack mounted by attaching metal flanges, known as ears (supplied), to each end.

Expansion Slots

The 16 open card cage slots accept 2-Series and most X-Generation expansion cards.

Slots 1 through 4 accept Ethernet Z-Bus cards, either the C2ENET-1 or C2ENET-2.

These are network interface cards that connect the 2-Series control system to the

Ethernet network. Each of the following cards provides 254 IP IDs for Ethernet

devices.

NOTE: Even though four slots are available, only ONE C2ENET card may be

installed in slot 1. The remaining three slots (2, 3, and 4) are for future expansion.

• The C2ENET-1 card provides one LAN port with an RJ-45 connector for

connecting to the Ethernet network.

• The C2ENET-2 card provides two LAN ports and a network address

translator. This allows a private sub-network to be created within a larger

LAN. Here the LAN A side of the C2ENET-2 card has one public IP

address that is visible to the larger network, while the LAN B side consists

of private IP addresses not visible to the larger network. In this way, the

sub-network of controlled Ethernet devices can be configured without need

to obtain multiple IP addresses from a network administrator or ISP.

Slots 5 through 16 accept X-Generation and 2-Series Y-Bus cards.

NOTE: The X-Generation CNXCOM-2 card is not supported.

Operation Guide – DOC. 5958 2-Series Card Cage System: RACK2 • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Keine Kommentare

Crestron CPU2 Spezifikationen Seite 11