Crestron ST-IO Spezifikationen PDF herunterladen (Seite 10)

Input/Output Module Crestron ST-IO

NET

This yellow LED illuminates when communication between Cresnet and the ST-IO

is established. Illumination indicates that the SIMPL Windows program currently

loaded has a network device defined with the same network ID as the ST-IO.

Input (1 through 4)

These red LEDs illuminate when the respective signal to the digital input is logic 1.

RELAY (1 through 8)

These red LEDs illuminate when the respective relay is closed.

Industry Compliance

As of the date of manufacture, the ST-IO has been tested and found to comply with

specifications for CE marking and standards per EMC and Radiocommunications

Compliance Labelling.

NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Setup

Identity Code

All equipment and user interfaces within the network require a unique identity code

(Net ID). These codes are two-digit hexadecimal numbers from 03 to FE. The Net

ID of each unit must match an ID code specified in the SIMPL Windows program.

Refer to “Setting the Net ID in Device Settings” on page

11 for details of the SIMPL

Windows procedure.

The Net ID of the ST-IO has been factory set to 14, The Net IDs of multiple ST-IOs

in the same system must be unique. Net IDs are changed from a personal computer

(PC) via the Crestron Viewport.

Refer to the note on page 13 for a

definition of Viewport.

NOTE: For detailed information on establishing communication between the PC

and control system, refer to “Communication Settings” on page 13. If

communication cannot be established, refer to the “Troubleshooting

Communications” section in the respective Operations Guide for the control system.

Use the following instructions to set or change the Net ID.

1. Ensure that the device requiring a Net ID change is the only unit connected

to the control system.

2. Open the Crestron Viewport.

6 • Input/Output Module: ST-IO Operations Guide - DOC. 5675A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Crestron ST-IO Spezifikationen Seite 10