Crestron MC2W Spezifikationen PDF herunterladen (Seite 21)

Crestron MC2W 2-Series Integrated Wireless Control System

MC2W Troubleshooting (Continued)

TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION

RF device

commands are not

received.

Incorrect operating

frequency set in SIMPL

Windows.

Set correct operating

frequency in SIMPL

Windows.

A/V system device

does not respond.

IRP2 or serial port not

placed properly.

Verify placement of IRP2

(Hold phosphor card under

IRP2 while pressing button)

and tighten serial cables.

Used wrong IR/Serial

port.

Verify that proper IR or serial

port is defined.

Serial cable not wired

correctly.

Verify that serial cable is

wired correctly for RS-232,

422, or 485.

Device is not receiving

sufficient power.

Confirm system power factor.

Add additional power supplies

as needed.

NOTE: If communication cannot be established or the control system is locked-up,

refer to “Troubleshooting Communications” in the Crestron 2-Series Control System

Reference Guide (Doc. 6256).

NOTE: Passthrough Mode enables ToolBox access to any serial controlled device

on the network. This aids in troubleshooting by allowing direct communication

between the PC and a network device (effectively “passing through” the MC2W).

For information pertaining to Passthrough Mode, refer to “Passthrough Mode” in the

Crestron 2-Series Control System Reference Guide (Doc. 6256).

System Monitor

The System Monitor allows you to reload firmware into the MC2W in the event that

you cannot load the firmware in the normal mode.

If the system does not function, perform the following procedure:

1. Connect the COMPUTER port on the MC2W to one of the COM ports

(usually COM1) on the PC. Use a straight-through RS-232 cable with a

DB9 male connector on one end and a DB9 female connector on the other.

Most commercially available cables are acceptable; they should have at

least five pins for transmit, receive, ground and hardware handshaking

(pins 2, 3, 5, 7 and 8).

2. Open Toolbox and start the Text Console (click the

icon). Then, click

on the Address Book icon in the lower left corner of the window to open

the “Address Book” window.

3. In the “Address Book” window, click the “Add Entry” button and give the

new entry a name (e.g. “System Monitor”).

4. Click the arrow next to the “Device Type” drop down list. A “Warning”

window will open to inform you that this is an advanced feature. Click

Okay, then select “2-Series Control System Monitor” from the drop down

list and click Okay. When you are returned to the “Address Book”

window, make sure to choose RS-232 as the “Connection Type” and the

correct Com port next to “Port”.

5. Power down the MC2W.

Operations Guide – DOC. 6143A 2-Series Integrated Wireless Control System: MC2W • 17

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron MC2W Spezifikationen Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Crestron MC2W