Crestron CP3 Spezifikationen PDF herunterladen (Seite 17)

Crestron CP3 3-Series Control System™

Operations Guide – DOC. 7316A 3-Series Control System™: CP3 • 13

Stacking

Four “feet” are provided with the CP3 so that if the unit is not rack mounted, the

rubber feet can provide stability when the unit is placed on a flat surface or stacked.

These feet should be attached prior to the hookup procedure. Refer to the following

illustration for placement of the feet.

Foot Placement for the CP3

NOTE: No more than two CP3 units should be stacked.

Hardware Hookup

Connect the Device

Make the necessary connections as called out in the illustration that follows this

paragraph. Refer to “Network Wiring” on page 10

before attaching the 4-position

terminal block connector. Apply power after all connections have been made.

When making connections to the CP3, note the following:

• Use Crestron power supplies for Crestron equipment.

• The included cable(s) cannot be extended.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

Crestron CP3 Spezifikationen Seite 17