Crestron C2N-NPA8 Spezifikationen PDF herunterladen (Seite 19)

Crestron C2N-NPA8 Network Poll Accelerator

“Port Settings” Window: Settings for RS-232 Communication with the C2N-NPA8

To verify communication, click Diagnostics | Establish Communications (Find

Rack). This should display a window that gives the COM port and baud rate.

Configuring for TCP/IP Communications

Once communications have been established between the PC and the C2N-NPA8,

perform the following procedure to configure the C2N-NPA8 for TCP/IP

communications.

NOTE: The terms used in the following steps are explained in detail in the Crestron

e-Control Reference Guide (Doc. 6052). The latest version is available as a PDF on

the Crestron website (www.crestron.com).

1. From the Viewport menu, click Functions | Set Control System IP

Information.

2. Enter the IP address, IP Mask, Router IP address, Hostname, and

Domain name in the applicable fields and click OK.

3. After saving the IP address, an entry must be added to the C2N-NPA8

IP table to enable communications between the control system and the

C2N-NPA8. To add an IP table entry, click Functions | Setup IP

Table. The following illustration shows a sample IP table for a

C2N-NPA8 that will communicate via Ethernet to a 2-Series control

system at IP address 192.168.125.165.

Operations Guide – DOC. 6087A Network Poll Accelerator: C2N-NPA8 • 15

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Keine Kommentare

Crestron C2N-NPA8 Spezifikationen Seite 19