Crestron C2N-NPA8 Spezifikationen PDF herunterladen (Seite 17)

Crestron C2N-NPA8 Network Poll Accelerator

Wiring Power Connectors on C2N-NPA8 with CNPWS-75 Power Supply

C2N-NPA8

CNPWS-75

To Control System via TCP/IP

or Serial Communications

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to

do so could cause equipment damage or void the Crestron warranty.

NOTE: If a Cresnet device connected to a powered segment has its own power

source, remove the 24V line from the Cresnet connector on the C2N-NPA8.

Although equipment damage is unlikely, Crestron does not recommend applying two

power sources to the same segment.

Communication Connections

When using a PC for console operations on the C2N-NPA8, refer to “Establish a

Serial Connection” on page 14.

The C2N-NPA8 can also be connected to compatible control systems that are

equipped with an Ethernet port. Refer to “TCP/IP Communications Between a

Control System and the C2N-NPA8” on page 14.

NOTE: For a list of control systems that are compatible with the C2N-NPA8, refer

to “Compatible Control Systems” on page 6.

C2N-NPA8-Control System Communications

The C2N-NPA8 can communicate with a control system over serial or TCP/IP

communication. Only one method of communication can be used.

Serial Communications Between a Control System and the

C2N-NPA8

If a direct connection from a PC to the C2N-NPA8 is required for uploading

firmware or performing diagnostics, follow the steps described in “Establish a Serial

Connection” on page 14. If the C2N-NPA8 firmware is to be upgraded through a

connection to a control system, refer to “Uploading and Upgrading” on page 22.

Operations Guide – DOC. 6087A Network Poll Accelerator: C2N-NPA8 • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Keine Kommentare

Crestron C2N-NPA8 Spezifikationen Seite 17