Crestron C2N-HBLOCK Installationsanleitung PDF herunterladen (Seite 7)

Crestron C2N-HBLOCK Multi-Type Network Distribution Block

C2N-HBLOCK Physical Views

ALL CONNECTORS ARE IN PARALLEL

B C

POWER

b c

Y Z

3.30 in

(8.38 cm)

6.55 in

(16.64 cm)

CRESTRON

4.30 in

(10.92 cm)

5.55 in

(14.10 cm)

1.33 in

(3.38 cm)

N11785

ZA11736

C000000

MADE IN THE U.S.A.

Front Panel View

Bottom View

C2N-HBLOCK

There are three LEDs on the front panel of the C2N-HBLOCK. The LED

labeled POWER illuminates when 24VDC is attached to one connector

and is available at the remaining connectors. The Y and Z data signal

LEDs are used to diagnose wiring problems of the data signal input to the

C2N-HBLOCK. Refer to “Y and Z LED Illumination” on page 9 for

further information.

The C2N-HBLOCK mounting plate allows the unit to be installed into

any location that is convenient for Cresnet wiring. The mounting plate

can be removed to install the C2N-HBLOCK onto the CNXRMAK,

Crestron Rack Mount Kit (not supplied). The CNXRMAK is then

installed into a standard 19-inch wide equipment rack. Refer to “Rack

Installation” on page 5 for details.

NOTE: The CNXRMAK occupies two rack spaces (2U).

Operations & Installation Guide – DOC. 8157A Multi-Type Network Distribution Block • 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Crestron C2N-HBLOCK Installationsanleitung Seite 7