Crestron PMK-6X-DSW Installationsanleitung PDF herunterladen (Seite 16)

Wall Mount Docking Station for TPS-6X Crestron TPS-6X-DSW

Removal

If it is necessary to remove the TPS-6X-DSW after it has been installed, complete

the following steps in the order provided. The only tool required is a #2 Phillips

screwdriver.

1. Undock the touchpanel. Refer to “Undocking the Touchpanel” which starts

on page 13 for details.

2. Push the TPS-6X-DSW mechanism backward, into the box, until it locks in

place, exposing the screws securing the bezel on the left and right sides.

(Refer to illustration on previous page.)

3. Remove the screws and washers, two from the left side and two from right

side, which secure the bezel and gently remove the bezel from the

TPS-6X-DSW.

4. Remove the screws, two from the top and two from the bottom, which

secure the TPS-6X-DSW to the back box. (Refer to illustration on page 11.)

5. If necessary, secure and label the attached cables before disconnecting them

from the TPS-6X-DSW.

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this

paragraph. Refer to “Network Wiring” on page 7 before attaching the 4-position

terminal block connector. Apply power after all connections have been made.

When making connections to the TPS-6X-DSW, use Crestron power supplies for

Crestron equipment.

Hardware Connections for the TPS-6X-DSW

NET:

To Control System

and Other Cresnet

Devices

LAN:

10 BASE-T / 100 BASE-TX

Ethernet to LAN

VIDEO IN (UNBL):

Unbalanced Video

Input

VIDEO IN (BAL):

Balanced Video

Input

12 • Wall Mount Docking Station for TPS-6X: TPS-6X-DSW Operations & Installation Guide – DOC. 6708B

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Crestron PMK-6X-DSW Installationsanleitung Seite 16