Crestron TPS-G-TPI Spezifikationen PDF herunterladen (Seite 17)

Crestron Isys

TPS-G-TPI G-Series Touchpanel Interface

NOTE: In the case of the QM 2 input port, the maximum cable length will vary. See

the QM Input # 2 Maximum Cable Length table on page 10.

When connecting multiple QM devices, the route between a QM origination point

(transmitter) and a QM endpoint (receiver) cannot have more than two midpoints

(e.g., QM-MD7x2 or other QM switchers). Refer to the following diagram when

configuring a QM network.

QM Network Topology

The TPS-G-TPI is not a switcher, but a QM transmitter. Therefore, even when

designated as the endpoint from two midpoint switchers, the QM output of the

TPS-G-TPI can become another transmitter sending RGB video at the touchpanel’s

native resolution and aspect ratio. Refer to the following diagram.

QM Network Topology with TPS-G-TPI Acting as an Endpoint and a Transmitter

QM-WMC

Origination Points Endpoints

TPS-G-TPI

This QM-RMCRX-BA

does not violate the

two-midpoint rule as it

is receiving an RGB

signal from the

TPS-G-TPI transmitter.

QM-RMCRX-BAQM-MD7x2 QM-MD7x2

Midpoints

This TPS-G-TPI acts

as both an endpoint

for signals from the

QM-WMC origination

points AND a QM

transmitter to the

QM-RMCRX-BA.

Identity Code

All equipment and user interfaces within the network require a unique identity code

(Net ID). These codes are two-digit hexadecimal numbers ranging from 03 to FE

(Net ID 02 is reserved for control processors). The Net ID of each unit must match

an ID code specified in the SIMPL Windows program. The Net ID is set using the

internal setup menu (refer to “Interface Menu” on page 16). The Net ID may also be

changed using Crestron Toolbox (refer to “Establishing Communications” on page

41).

Configuring the Interface

NOTE: In order to configure the TPS-G-TPI interface, power (supplied via Cresnet)

and a connection to an external touchpanel or other video device are required. Refer

to “Hardware Hookup” on page 31 for details.

Operations Guide – DOC. 6445 Isys

G-Series Touchpanel Interface: TPS-G-TPI ¥

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron TPS-G-TPI Spezifikationen Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Crestron TPS-G-TPI