Crestron TPS-G-TPI Spezifikationen PDF herunterladen (Seite 15)

Crestron Isys

TPS-G-TPI G-Series Touchpanel Interface

Pushbuttons

There is only a single, recessed button on the front panel of the TPS-G-TPI interface.

It is the hard reset used to reboot the interface.

TPS-G-TPI Pushbuttons

HARD RESET

BUTTON

Industry Compliance

As of the date of manufacture, the TPS-G-TPI, has been tested and found to comply

with specifications for CE marking and standards per EMC and Radio

communications Compliance Labeling.

NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Setup

Network Wiring

CAUTION: In order to ensure optimum performance over the full range of your

installation topology, Crestron Certified Wire, and only Crestron Certified Wire, may

be used. Failure to do so may incur additional charges if support is required to

identify performance deficiencies as a result of using improper wire.

CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to

do so could cause equipment damage or void the Crestron warranty.

CAUTION: Provide sufficient power to the system. Insufficient power can lead to

unpredictable results or damage to the equipment. Please use the Crestron Power

Calculator to help calculate how much power is needed for the system

(http://www.crestron.com/calculators

When calculating the length of wire for a particular Cresnet run, the wire gauge and

the Cresnet power usage of each network unit to be connected must be taken into

consideration. Use Crestron Certified Wire only. If Cresnet units are to be daisy-

chained on the run, the Cresnet power usage of each network unit to be daisy-

chained must be added together to determine the Cresnet power usage of the entire

chain. If the unit is a home-run from a Crestron system power supply network port,

the Cresnet power usage of that unit is the Cresnet power usage of the entire run. The

Operations Guide – DOC. 6445 Isys

G-Series Touchpanel Interface: TPS-G-TPI ¥

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 65 66

Keine Kommentare

Crestron TPS-G-TPI Spezifikationen Seite 15