Crestron CHV-RTS Bedienungsanleitung PDF herunterladen (Seite 22)

infiNET EX™ Thermostat Crestron CHV-TSTATEX

NOTE: The acquire process can take up to 15 seconds. The acquire process cannot

be aborted.

NOTE: “E1” indicates that search time has expired and no gateway was found.

“E1” indicates the RF channel is set to “0” (disabled). To enable the RF channel,

refer to “Start infiNET EX Acquire” in “Setup Mode Parameters/Functions” which

starts on page 20.

Leaving an infiNET EX Network

To leave a network, press and hold the FAN, and buttons simultaneously for

five seconds. Press MODE until the unacquire function is displayed (UA). Press

on the CHV-TSTATEX to start the unacquire process. Once completed, press

FAN on the thermostat to exit Setup mode.

Verifying Communication Status

To verify communication status, enter the Setup mode as described in “Basic

Thermostat Setup” on page 17. Press MODE until the “CC” function is displayed.

Press or on the CHV-TSTATEX to verify the communication status.

Communication Error Codes

ERROR

CODE

SUMMARY CORRECTIVE ACTION REMARKS

00 Success None. No detectable problems found.

Low battery

warning

Check and/or replace

batteries, investigate

battery drain rate.

Set when the capacity is below approximately 10%

and the device needs battery power (i.e. not using

24VAC mode).

24VAC supply

usage warning

Confirm desired power

connection and S2

position setting.

Set when constant 24VAC is detected but the

internal bus voltage does not meet run threshold.

This can happen when 24VAC is available but S2

is set to power-steal. This is not an error but warns

that better performance may be achieved by

changing S2 position.

Display timing

error

None, consider

replacement of unit.

Set when timing parameters for display operation

cannot be met. Device may be usable but proper

display operation cannot be guaranteed.

NV memory

usage error

Replace unit when

feasible.

Set when internal NV memory usage has

exceeded its rated life. Device will continue to

operate but data retention may be in question.

Application LQI

poor

Perform general RF

debugging to improve

communications.

Link quality to gateway is poor and may indicate

communications problems that can impact timely

data exchange or battery life.

GW addressing

info missing

Run acquire operations if

communication is needed.

Device cannot address a gateway. This may

simply mean the device has not been acquired

yet.

ZigBee network

join error

Run acquire operations if

communication is needed.

Device is not joined to a ZigBee network. This may

simply mean the device has not been acquired

yet.

Excessive link

cost

Perform general RF

debugging to improve

communications

Network link to gateway is not desirable.

Communication may work ok but is subject to

many hops that will impact communication speed

and battery life.

18 • infiNET EX™ Thermostat: CHV-TSTATEX Operations & Installation Guide – DOC. 6989A

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron CHV-RTS Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern