Crestron WMKM-4L Bedienungsanleitung PDF herunterladen (Seite 12)

Mud Mount Kits Crestron MMK-4L & WMKM-4L

Bend Flanges

10. Use four standard drywall screws (of adequate length) to secure the plate to

the adjustment/mounting plate assembly. The screws pass through the

clearance holes in the plate and are secured in the extruded holes of the

adjustment plates.

11. Verify that the plate is level before tightening.

NOTE: Do not over tighten screws. Doing so may damage the plate.

12. Use a #2 Phillips screwdriver and tighten the drywall screws by hand so that

they slightly dimple into the holes in the mud ring plate.

13. Run the necessary cables for the touchpanel and secure them behind the

drywall.

14. Apply drywall joint compound as needed to finish the cutout. Avoid

covering the four tapped mounting holes.

15. When the joint compound is dry, the touchpanel can be installed using the

four tapped holes in the mounting plate. Refer to the latest revision of the

TPS-4L Operations and Installation Guide (Doc. 6449) for details. Refer

also to the comprehensive illustration on the following page.

10 • Mud Mount Kits: MMK-4L & WMKM-4L Installation Guide – DOC. 6389A

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Crestron WMKM-4L Bedienungsanleitung Seite 12