Crestron CT-1600 Spezifikationen PDF herunterladen (Seite 10)

Wired Touchpanels Crestron Series 1600

NOTE: All network wiring must consist of two twisted-pairs. One twisted pair is

the +24V conductor and the GND conductor and the other twisted pair is the Y

conductor and the Z conductor.

NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to

avoid nicking the conductors. Twist together the ends of the wires that share a pin on

the network connector, and tin the twisted connection. Apply solder only to the ends

of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.

Insert the tinned connection into the Cresnet connector and tighten the retaining

screw. Repeat the procedure for the other three conductors.

Hardware Hookup

Due to physical differences, the lectern and tiltcase models require different hookup

procedures. Furthermore, the lectern model installs simply and cleanly into existing

or newly constructed walls (or other suitable mounting surface). Back box and

drywall mounting options are available. The stylish, elegant design accommodates

painting of its “Designer Series” cover. The necessary mounting hardware (for the

drywall option) is provided with each model.

Back Box Mounting

Back box mounting, shown after this paragraph, is typically used at new construction

sites. The optional back box, BB-1600, includes the necessary hardware, brackets,

and electrical box, which provides a secure enclosure that, can be fastened directly to

the mounting surface. This mounting method is optional and requires the BB-1600

(sold separately). Details for installation are provided in the latest revision of the

BB-1600 Installation Guide (Doc. 5835).

Back Box Mounting

BB-1600

(INSTALLED)

DRYWALL

TOUCHPANEL

COVER

PAN HEAD SCREWS

Drywall Mounting

Each Series 1600 Touchpanel is provided with four metal mounting plates (two

small and two large) and eight mounting screws to fasten the panel to a mounting

surface without an electrical box. Complete the following installation procedure in

the order provided. The only tools required are a pencil (or equivalent), drywall saw

(or equivalent), a Phillips tip screwdriver, a drill with a 5/16” bit, and a drill with a

#20 bit. Refer to the illustration after this paragraph as needed.

6 • Series 1600 Wired Touchpanels Operations & Installation Guide - DOC. 5836A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Keine Kommentare

Crestron CT-1600 Spezifikationen Seite 10