Crestron TPS-5000 Spezifikationen PDF herunterladen (Seite 13)

Crestron Isys™ TPS-5000L 12 Inch Lectern/Wall Mounted Touchpanel

Calibration Menu

CALIBRATION MENU

Calibration of the touchscreen is required if the active touch area of a button does

not coincide with the button's image. Select the Touch Screen Calibration

utton to

display the CALIBRATION MENU, shown to the left. The CALIBRATION MENU

offers the choice to initiate calibration with the Perform Calibration button or

return to the previous screen with the Return button. Choose an option by touching

the correct button.

If you proceed to calibrate the touchpanel, the screen displays the message "Touch

Upper Left" centered on the panel with a cross hair in the corner. Touch the cross

hair in the corner of the screen to initiate calibration. Another message, "Touch

Upper Right", appears with a cross hair in the correct corner. Touch the corner of the

screen. A final message, “Touch Lower Right”, appears with a cross hair in the

correct corner. Touch the corner of the screen to conclude calibration and return to

the MAIN MENU.

NOTE: When touching the screen during calibration, be as accurate as possible.

Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and

return to the CALIBRATION MENU without saving calibration data, create a

calibration error by touching the screen in an area that is opposite from the instructed

area.

Setup Menu

SETUP MENU

To access the SETUP MENU, shown to the left, press the Setup button from the

MAIN MENU. The SETUP MENU offers a series of buttons, which opens

additional menus and displays, which are detailed in subsequent paragraphs. Many

touchpanel options (i.e., standby timeout and brightness) are available directly from

the SETUP MENU and are explained in the following paragraphs. Other setup

parameters (i.e., interface, RS-232, audio, RGB, and video) use additional menus

and are detailed in subsequent paragraphs as well. After setup parameters have been

set, select the Return button to return to the MAIN MENU.

NOTE: The current CRESNET ID setting is displayed in the upper left corner of

the SETUP MENU.

NOTE: All touchpanel settings are automatically saved in non-volatile memory.

NOTE: The Ethernet, RGB, and Video buttons will only be displayed if the

respective TPS-ENETL, TPS-XVGAL or TPS-VIDL-1/2 cards are installed.

NOTE: If the TPS-VIDL-2 is installed, two video buttons will be displayed; “Video

1” and “Video 2”. Press the button for the respective video source.

The touchpanel display can be turned off (standby mode) when not in active use.

STANDBY TIMEOUT, located in the middle of the SETUP MENU, can turn off

the touchpanel when it is inactive for a specified time frame (minutes, shown as

XXX in the illustration). When the touchpanel is activated, the last screen to be

displayed reappears. Minutes can vary from 0 to 120, where 0 disables the timeout.

DOWN and UP buttons decrease and increase the timeout, respectively.

Screen brightness may need to be altered because of ambient light conditions or

personal preference. BRIGHTNESS, located in the lower left corner of the SETUP

Operations Guide - DOC. 5783A 12 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-5000L • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron TPS-5000 Spezifikationen Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Crestron TPS-5000