Crestron TPMC-8T Spezifikationen PDF herunterladen (Seite 21)

Crestron TPMC-8T-GA 8.4” TableTop WiFi Touch Screen

Operations Guide – DOC. 7262F 8.4” TableTop WiFi Touch Screen: TPMC-8T-GA

•

Once all changes to network connections have been completed, touch OK to return

to the Security Setup window.

The Certificates button can be used to install or uninstall certificates used for server

or user authentication when making a secure connection (for example, to a secured

wireless access point). In order to use certificates, the TPMC-8X-GA Security Pack

must be installed (refer to “Appendix: TPMC-8X-GA Security Pack” which starts

on page 44 for details).

Touch Close to return to the setup menu.

Touch Screen

When Touch Screen is touched, the calibration screen opens. Touch the screen to

begin the calibration process. If the screen is not touched within 10 seconds, the

calibration sequence stops and the screen displays the setup menu.

If the screen is touched within the 10-second timeout, it displays a series of messages

indicating the user should touch the red square in five places around the screen.

These messages appear sequentially starting with “Touch the red square” at the top

of the screen toward the upper left corner. Touch and hold the center of the red

square to initiate calibration. The message says “Hold…” for a few seconds, then

change to “Lift off to proceed”. Touch the displayed squares as prompted

everywhere they appear around the screen until the calibration is complete and the

display returns to the setup menu.

NOTE: When touching the screen during calibration, be as accurate as possible.

Use the tip of the included stylus. To cancel calibration and return to the setup menu

without saving calibration data, ignore the “Touch the red square” message. After

about 10 seconds, the setup menu opens. If a USB keyboard is attached to the touch

screen, pressing the Escape key (Esc) cancels calibration and returns to the setup

menu.

NOTE: The touch screen’s calibration routine can also be accessed through Crestron

Toolbox if the touch screen is connected to a control system via TCP/IP. From the

System Info page, select Functions > Setup Mode…. Select Enter Calibration

Mode to begin calibration.

Update Panel

The Update Panel button permits the selection of the touch screen program, a .vtz

file. The Project tab of the “Project and Firmware” window (refer to illustration on

the following page) displays the Current Loaded Project and also has a Load New

Project section.

Current Loaded Project displays the Name and Creation Time of the current

project.

In the Load New Project section, touch Browse and select the compiled project (the

.vtz file) to be loaded from a network drive, USB device or flash drive. The user can

choose the location where the uncompressed project files are to be stored. The

default file location is the internal flash. Touch Load to uncompress the project file,

place it in the destination selected in Target Location to Load the Project to and

display it on the touch screen.

NOTE: If there is a mapped network drive on the touch screen, the first time

Browse is selected, it may take some time for the Open window to appear.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Crestron TPMC-8T Spezifikationen Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Touchscreen-Monitore Crestron TPMC-8T