
Remote Slab & Outdoor Temperature Sensor Crestron CHV-RSS
6
Remote Slab/Outdoor Temperature Sensor: CHV-RSS Installation Guide – DOC. 6229D
NOTE: In tile floors, ensure a channel is made in the thin-set mortar, just
above the subflooring, to properly position the sensor.
Outdoor Installation
Required Materials (not supplied):
• Two wood screw coaxial cable standoffs with insulators
• One plastic feedthrough bushing
• Silicon adhesive
NOTE: Mount in a location away from direct sunlight.
NOTE: Sensor should not come in contact with metal objects.
Complete the following procedure to install the CHV-RSS:
1. Mount the sensor using two coaxial cable standoffs. If the fit is not
snug, use silicon adhesive to secure the sensor in place.
2. Use a plastic feedthrough bushing and pass the wires through the
outside wall.
3. Form a drip loop in the wire to prevent moisture from entering the
building.
Kommentare zu diesen Handbüchern