Crestron CHV-TSTATEX-FCU Installationsanleitung PDF herunterladen (Seite 20)

infiNET EX Thermostat (Fan Coil Unit) Crestron CHV-TSTATEX-FCU

•

infiNET EX Thermostat (Fan Coil Unit): CHV-TSTATEX-FCU Operations & Installation Guide – DOC. 7206C

Basic Setup

Basic Thermostat Setup

The following describes the most common setup requirements. For full details on all

setup options, refer to “Advanced Setup” which starts on page 18.

Place the CHV-TSTATEX-FCU in the Setup mode by doing the following:

1. Press and hold the FAN button.

2. While the FAN button is being held, press and hold the

and buttons

simultaneously.

3. Hold all three buttons for 5 seconds, after which the unit enters Setup mode.

The display shows the Temperature Scale function (FC).

Use or to choose the temperature units: F (setpoint in whole degrees

Fahrenheit), C1 (setpoint in whole degrees Celsius) or C2 (setpoint in half degrees

Celsius).

When setting parameters (such as when choosing between Fahrenheit or Celsius

display), pressing the

or button increments or decrements the value. Value

change occurs when button is released.

Joining an infiNET EX Network

Before a CHV-TSTATEX-FCU can be used on an infiNET EX network, it must first

join an infiNET EX network by being acquired by an infiNET EX gateway (e.g.,

CEN-RFGW-EX).

NOTE: A CHV-TSTATEX-FCU can be acquired by only one gateway.

To acquire a CHV-TSTATEX-FCU, perform the following:

1. Put the CEN-RFGW-EX into Acquire mode, from the unit itself or from

Crestron Toolbox, as described in the latest revision of the CEN-RFGW-EX

Operations & Installation Guide (Doc. 6706), which is available from the

Crestron Web site (www.crestron.com/manuals

NOTE: In an environment where multiple gateways are installed, only one

gateway at a time should be in Acquire mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Keine Kommentare

Crestron CHV-TSTATEX-FCU Installationsanleitung Seite 20