Crestron SW-MAIL Spezifikationen PDF herunterladen (Seite 54)

Crestron e-control Mail SW-MAIL

54 •• Demos Installation & Reference Guide — Doc. 5798

example. Note that the Send e-Mail symbol’s rx and tx streams are connected to the

(virtual) COM port symbol.

Demo 2 Block Diagram

NOTE: This block diagram shows the use of a virtual COM port for TCP/IP communications with

the server. For serial communications using RS-232, the virtual COM port is simply replaced with a

real COM port.

LookupRcpt is an analog signal whose value represents a “key” (a record ID

number) which is used to “look up” a name and address from an address book table.

LookupMsg is used similarly to “look up” a subject and a message body from a

table of messages.

Notice how LookupMsg also supplies a default recipient name and address through

the message table’s defaultAddr field, or, if no name and address are discovered that

way, using the e-mailer signal block’s defaults. This behavior is laid out in detail in

the section titled “Implicit Recipient Name & Address,” page 47. However, it is

much easier to appreciate when you see it in action here (and in demo 3 as well), by

performing the following actions:

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 108 109

Keine Kommentare

Crestron SW-MAIL Spezifikationen Seite 54