Crestron FlipTop FT-TS600 Installationsanleitung PDF herunterladen (Seite 16)

FlipTop Touch Screen Crestron FT-TS600

12 • FlipTop Touch Screen: FT-TS600 Operations & Installation Guide – DOC. 7585A

Setup

Network Wiring

When wiring the Ethernet network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

Unlike other Crestron network devices, the FT-TS600 does not use Cresnet

for

communications between the device and the control system. The FT-TS600 requires

the use of a high-speed Ethernet connection for control system communications.

For general information on connecting Ethernet devices in a Crestron system, refer to

the Crestron e-Control



Reference Guide (Doc. 6052) at

www.crestron.com/manuals.

Identity Code

NOTE: The latest software can be downloaded at www.crestron.com/software.

The IP ID is set within theFT-TS600’s IP table using Crestron Toolbox™. For

information on setting an IP table, refer to the Crestron Toolbox help file. The IP IDs

of multipleFT-TS600 devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the Crestron

Studio™ or SIMPL Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Configuring the Touch Screen

NOTE: The only connection required to configure the touch screen is power. Refer

to “Hardware Hookup” on page 28 for details.

NOTE: The FT-TS600 can take up to 45 seconds to boot to a display after initial

power up.

Access the Setup Screens

The “Setup” menu is the starting point for configuring the FT-TS600.

NOTE: If no project has been loaded or if an invalid project has been loaded, the

screen displays a message saying “There is no display project to start. [Touch Screen

to Enter Setup…]”

The setup screens enable basic configuration procedures prior to regular operation of

the touch screen.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Crestron FlipTop FT-TS600 Installationsanleitung Seite 16