Crestron DA-1700CW Installationsanleitung PDF herunterladen (Seite 11)

Crestron DA-1700CW Docking Assembly for STX-1700CW/CXPW

6. Click the Set ID button to initiate the change. This should display the

confirmation message, “ID command has been sent”.

7. In the "Command Complete" window, click OK.

8. In the Current Network Devices text window, verify the new Net ID

code.

9. In the "Set Network ID" window, click Close.

NOTE: The new Net ID code may also be verified by selecting Diagnostic | Report

Network Devices in the Viewport (alternately, select F4).

10. Repeat this procedure for each DA-1700CW to be added to the system.

Installation

To install the DA-1700CW, complete the following installation procedure in the

order provided. Tools required are a #2 Phillips screwdriver and a 5/64-inch hex

wrench.

NOTE: This procedure is performed only after the BB-1700CW back box

(optional) has been installed. Make sure that the back box is installed inward of the

face of the gypsum board to accommodate the distance between the back box and the

front panel. For further information, refer to the latest revision of the BB-1700CW

Installation Guide (Doc. 6105). The latest version can be obtained from the Crestron

website.

1. Position the DA-1700CW to the back box and connect the Cresnet

wiring to the rear port using the supplied connector. The rear port

connections are shown in the following graphic. Refer to “Network

Wiring” on page 5 if necessary.

2. As shown in the following illustration, position the DA-1700CW into

the back box. Install four Phillips screws (supplied) to finger-tight

then, using a #2 Phillips screwdriver, tighten an additional 1/8-turn.

Operations and Installation Guide - DOC. 6104A Docking Assembly for STX-1700CW/CXPW: DA-1700CW • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Keine Kommentare

Crestron DA-1700CW Installationsanleitung Seite 11