Crestron TPS-IMC-BV Spezifikationen

Crestron Touch The PC Driver Software Programmer’s Guide Intended for Version 3.08.34 and Later

Software Crestron Touch The PC Driver Serial Communication #2 - Tilt Touchpanel with TPS-XVGA-BV RGB CABLEPCTILT TOUCHPANELWITH TPS-XVGA-BVRGBPORTRG

Crestron Touch The PC Driver Software PC to Touchpanel Cresnet Communication For Touch the PC V2 operation using Cresnet communication to the touchp

Software Crestron Touch The PC Driver PORT CONNECTOR to CONNECTOR DEVICE PORTA 1VGA DB-15, male DB-15, male TPS-IMC-BV RGBB 2RGB RJ-45, 10-pin RJ-45,

Crestron Touch The PC Driver Software NOTE: A Crestron TPS-ENET or TPS-ENETL Ethernet expansion card must be installed in the touchpanel to enable

Software Crestron Touch The PC Driver Ethernet Communication #2 - Tilt Touchpanel with TPS-XVGA-BV RGB CABLEPCTILT TOUCHPANELWITH TPS-XVGA-BVCOMPORT

Crestron Touch The PC Driver Software Ethernet Communication #3 - Lectern Touchpanel with TPS-XVGAL RGBINPUTPORTRGB CABLEPCLECTERN TOUCHPANEL(OR TP

Software Crestron Touch The PC Driver IP Table 3. As shown below, using the addm (ADDMASTER) command to add a CIP node to the master list of the to

Crestron Touch The PC Driver Software SIMPL Windows Programming With a Cresnet or Ethernet connection (serial connection does NOT require SIMPL Wind

Software Crestron Touch The PC Driver Device Settings of the RS-232 COM Port in SIMPL Windows’ Configuration Manager 4. Compile and upload the SIMP

Crestron Touch The PC Driver Software Select Project Properties 4. In the “Project Properties” window, select the Pad Area tab. 5. Refer to the d

This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647

Software Crestron Touch The PC Driver • 6a. If Serial is selected, proceed to step 7 below. • 6b. If Cresnet is selected, select the serial join nu

Crestron Touch The PC Driver Software 12. Save, compile, and load the project to the touchpanel. 13. The Touch the PC V2 is ready for operation.

Software Crestron Touch The PC Driver Touch the PC V2 Troubleshooting (continued) TROUBLEPOSSIBLE CAUSE(S)1.Double-click the system tray icon to disp

Crestron Touch The PC Driver Software You can also log onto the online help section of the Crestron website (www.crestron.com) to ask questions abou

Software Crestron Touch The PC Driver Appendix A – Additional Keyboard Functionality VT Pro-e button objects can simulate up to fifteen computer and

Crestron Touch The PC Driver Software Appendix B – Cable and Wiring Specifications Network Wiring CAUTION: Use only Crestron power supplies for Cre

Software Crestron Touch The PC Driver Insert the tinned connection into the Cresnet connector and tighten the retaining screw. Repeat the procedure f

Crestron Touch The PC Driver Software DB9F to RJ-11 Cable Fabrication In the event that modular cables or the DB9F to RJ-11 adapter is not readily a

Software Crestron Touch The PC Driver Software License Agreement This License Agreement (“Agreement”) is a legal contract between you (either an indi

Crestron Touch The PC Driver Software If You are a business or organization, You agree that upon request from Crestron or its authorized agent, You

Crestron Touch The PC Driver Software Contents Touch the PC Driver 1 Introduction ...

Software Crestron Touch The PC Driver Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit

Crestron Touch The PC Driver Software This page intentionally left blank. Programmer’s Guide –

Crestron Electronics, Inc. Programmer’s Guide – DOC. 5916B 15 Volvo Drive Rockleigh, NJ 07647 09.04 Tel: 888.CRESTRON Fax: 201.767.7576 Spe

Crestron Touch The PC Driver Software Touch the PC Driver Introduction The Crestron® Touch the PC Driver, V2 (Touch the PC V2), licensed for use onl

Software Crestron Touch The PC Driver Driver Requirements REQUIREMENT SPECIFICATION Touch the PC V2 (UPDD*) Version 3.08.34 or later1 VisionTools P

Crestron Touch The PC Driver Software Touch the PC V2 Operation via Cresnet Communications • Install Touch the PC V2 software (page 3) • Connect C

Software Crestron Touch The PC Driver window, a COM port other than the default COM1 can be selected, to specify the COM port from which the PC will

Crestron Touch The PC Driver Software Configuring the System The touchpanel may be configured for serial, Cresnet, or Ethernet communication with th